Page Comparison

Create Feature

Create a new feature. Will be disabled if editing is in progress.

Update Feature

Change the currently selected feature. Will be disabled if no feature is selected, if there is more than one feature selected, or if editing is in progress.

Delete Feature

Remove the currently selected feature. Will be disabled if no feature is selected,  if there is more than one feature selected, or if editing is in progress.

Reset Form

Reset the form fields back to their original values. Will be disabled if editing is not in progress.

Submit Changes

Complete the edit process and save the current changes. Will be disabled when editing is not in process or if the current state is not valid, for example if a polygon geometry is required but hasn't yet been added.

Cancel Changes

Abort the edit process and abandon the current changes. Will be disabled when editing is not in progress.

Modify Geometry

Modify an existing geometry. Will be disabled if there is no feature selected. You can modify an existing feature (using the Update tool) or one that you are in the process of creating (using the Create tool). Modifications can be made by:

• Using the centre node (shown as an orange circle): Click and drag the point, line or polygon to a new location.
• Using the vertices and end points (shown as orange circles): Click and drag the vertex/end point to a new location. Or hold your mouse over the vertex/end point and press the Delete key to delete it. 
• Using the edge mid-points (shown as faded orange circles in the middle of an edge): Click on new node to add and/or move node to a new location. 

Create Geometry

• Point - Create a new point. Will be disabled if the entity doesn't support point geometry or if it only supports a single point and there already is a point attached to the entity.
• Line - Create a new line. Will be disabled if the entity doesn't support line geometry or if it only supports a single line and there already is a line attached to the entity.
• Polygon - Create a new polygon. Will be disabled if the entity doesn't support polygon geometry or if it only supports a single polygon and there already is a polygon attached to the entity.

Delete Geometry

Remove the currently selected geometry. Will be disabled if there is no geometry enabled or if the entity requires some geometry and this is the last piece of geometry related to the entity.

Import geometry from another entity. The

feature must firstly be selected from the other entity/Active Layer.

From Weave 2.5.29, this tool can be used for the import of geometry and/or attributes. 

Enable Snapping

Toggle the snapping function on and off.

Snap Settings

Changes the snap settings.